Açıklama

Features

Supports Raspberry Pi Compute Module 4/5 (wireless supported variants)
2400-2500/5100-5800 MHz frequency range with 100–700MHz bandwidth
Vertical polarization with 50-ohm impedance
Shell made of ABS

Description

This Antenna Kit is certified for use with the Raspberry Pi Compute Module 4/5(CM4). If a different antenna is used, then separate certification will be required, and this must be arranged by the end-product design engineer.

Specifications

Specification	Details
Antenna
Model number	YH2400-5800-SMA-108
Frequency range	2400-2500/5100-5800 MHz
Bandwidth	100–700MHz
VSWR	≤ 2.0
Impedance	50 ohm
Polarization	Vertical
Radiation	Omnidirectional
Maximum power	10W
Connector	SMA (female)
Dimensions	108 mm × 10 mm
Shell material	ABS
Installation	Screw
Operating temperature	-35 to +75°C
Weight	± 3 g

SMA to MHF1 cable
Model number	HD0052-09-A01_A0897-1101
Frequency range	0–6GHz
Impedance	50 ohm
VSWR	≤ 1.4
Maximum power	10W
Connector (to antenna)	SMA (male)
Connector (to CM4)	MHF1
Dimensions	205 mm × 1.37 mm (cable diameter)
Shell material	ABS
Operating temperature	-45 to +80°C
Compliance	For a full list of local and regional product approvals, please visit: www.raspberrypi.org/documentation/hardware/raspberrypi/conformity.md

Fitting Instructions

1. Connect the MHF1 connector on the cable to the MHF connector on the Compute Module 4/5
2. Screw the toothed washer onto the SMA (male) connector on the cable. then insert this SMA connector through a hole (e.g. 6.4 mm) in the end-product mounting panel
3. Screw the SMA connector into place with the retaining hexagonal nut and washer
4. Screw the SMA (female) connector on the antenna onto the SMA (male) connector which now protrudes through the mounting panel
5. Adjust the antenna to its final position by turning it through up to 90°, as shown in the illustration below